CZF-5水平垂直燃烧测定仪

 CZF-5水平垂直燃烧测定仪是根据标准ANSI/UL94、IEC60950-1、IEC695-2-2、GB/T2408-2008而研制的，完全满足国家标准GB/T2408 规 定的技术要求。可在同一台仪器进行塑料水平燃烧和垂直燃烧两种方法的试验。Is studied and manufactured according to the standard ANSI/UL94, iec60950-1, IEC695-2-2, GB/T2408-2008 CZF-5 horizontal and vertical burning tester, fully meet the national standard / t2408 GB regulation technology. Can be used in the same instrument for plastic horizontal combustion and vertical burning test of two methods.设备规定了在实验室内对水平和垂直方向放置的式样用小火焰火源点燃后，测定式样的燃烧速度，有焰燃烧和无焰燃烧时间。The device provides a small flame ignition source for the horizontal and vertical arrangement in the laboratory, and the combustion rate of the pattern is determined.CZF-5水平垂直燃烧测定仪适用范围与标准Application range and standard of CZF-5 horizontal vertical burning tester设计国标：GB-T2408-2008《塑料燃烧性能的测试-水平法和垂直法》Design GB: GB-T2408-2008 "plastic combustion performance test - horizontal and vertical method"适用标准：UL94-2006、GB-T 5455 、 GB-T13488 、GB-T5169、 IEC60695-11-3、IEC60695-11-4、IEC60950-1、IEC695-2-2Applicable standards: UL94-2006, GB-T 5455, GB-T13488, GB-T5169, IEC60695-11-3, IEC60695-11-4, iec60950-1, IEC695-2-2CZF-5水平垂直燃烧测定仪工作条件Working conditions of CZF-5 horizontal vertical burning tester序号 项目 参数Item parameters1 环境温度 -10℃～30℃1 ambient temperature -10 C ~ 30 C2 相对湿度 ≤85％2 relative humidity is less than 85%3 供电电压和功率 220V±10％50HZ功率150W3 power supply voltage and power 220V + 10%50HZ power 150WCZF-5水平垂直燃烧测定仪技术参数Technical parameters of CZF-5 horizontal vertical burning tester序号 项目 参数Item parameters1 燃烧器 内径Φ9.5mm+0.3mm单气体及内径Φ9.5mm±0.5mm本生灯1 inner diameter 9.5mm+0.3mm single gas burner and the inner diameter is 9.5mm + 0.5mm bunsen2 本生灯带有空气调节螺母 用来调节蓝色火焰高度2 the lamp with air conditioning nut is used to adjust the height of the blue flame.3 本生灯自动点火时间 任意设定3 automatic ignition time of the automatic ignition4 燃烧器试验倾角 0～45°可调节，可在0～45°之间每5°固定并来回切换4 burner test angle of 0 ~ 45 degrees can be adjusted, can be between 45 to 5 degrees per 0 degrees fixed and switching back and forth5 火焰高度 20mm+2mm到100mm+10mm可调5 flame height 20mm+2mm to 100mm+10mm adjustable6 本生灯通过电机快速移动到式样低端 施焰完毕本生灯自动退回6 the lamp through the motor quickly move to the low-end style application of flame after Bensheng lamp automatic return7 本生灯施焰时间 0～999.9S+0.1s可调，区间内任意设定，火焰调节20～175mm可调节7 the time of the birth of the lamp 0 ~ 999.9S+0.1s adjustable, adjustable range, the flame regulation 20 ~ 175mm adjustable8 余焰时间 0～999.9S+0.1s可调，仪器自动记录，手动暂停8 remaining flame time 0 ~ 999.9S+0.1s adjustable, automatic recording instrument, manual pause9 余灼时间 0～999.9S+0.1s可调，仪器自动记录，手动暂停9 burn time 0 ~ 999.9S+0.1s adjustable, automatic recording instrument, manual pause10 试验气源使用98%甲烷 煤气或液化石油气10 test gas source using 98% methane gas or liquefied petroleum gas11 甲烷流量 105ml/min-1000ml/min可调11 methane flow 105ml/min-1000ml/min adjustable12 燃气管路上设有电子开关 试验结束关闭面板上的燃气开关切断气源。本生灯自动熄灭12 the gas pipeline is provided with an electronic switch test end and the gas switch off the panel is cut off. This lamp is automatically extinguished13 燃烧箱体 0.5立方米，背景黑色，背景照度≤20Lux13 combustion box of 0.5 cubic meters, black background, background illumination is less than or equal to 20Lux14 式样架上下左右行程均大于300mm以上 式样水平和垂直均有伺服电机带动调节与火焰的距离14 style frame up and down around the stroke are more than 300mm above the horizontal and vertical patterns and vertical servo motor drive to adjust the distance with the flame15 试验箱顶部设有排风扇 试验结束，可排出有毒物质15 the top of the test box is provided with the end of the exhaust fan test, which can discharge the toxic substances.16 试验过程自动控制 独立抽风Automatic control of 16 independent exhaust test